TA871 : Physical Modeling and Investigation of the Behavior of Helical Pile Groups under Monotonic and Cyclic Loading
Thesis > Central Library of Shahrood University > Civil & Architectural Engineering > PhD > 2026
Authors:
[Author], Mohsen Keramati[Supervisor]
Abstarct: Abstract In recent years, helical piles have gained widespread application worldwide due to their unique characteristics. However, because these piles are still relatively unfamiliar, their use in Iran has remained limited. Numerous researchers around the world have investigated the behavior of helical piles and achieved valuable results. Despite the high efficiency of helical piles, particularly when used in pile groups to support larger loads, only a limited number of studies have been conducted in Iran, and most have focused on the behavior of single helical piles. Understanding the behavior of helical pile groups is essential due to the growing use of this type of foundation system and its numerous advantages. The rapid installation process, cost-effectiveness, and especially environmental compatibility resulting from the elimination of concrete usage distinguish helical piles from conventional pile foundations. In this research, several helical pile models were fabricated and installed in a physical modeling apparatus. Monotonic and cyclic loading tests were then applied to different helical pile group models in order to investigate their static and cyclic behavior under loading conditions similar to those experienced by machine foundations. The geometry of the helical piles was designed and developed baxsed on previous studies and existing dimensional analysis principles. After fabrication, Firouzkooh sand, one of the most well-known and widely used soils in geotechnical research in Iran, was prepared at different relative densities using the sand-raining technique. Subsequently, the pile group models were placed in a large-scale physical modeling box and subjected separately, under identical conditions, to monotonic loading followed by cyclic loading with different amplitudes. In these tests, the tensile and compressive capacities of the pile groups were evaluated under monotonic loading, while the number of cycles sustained by two-, three-, and four-pile groups was investigated under cyclic loading. The results indicated that, in sand with a relative density of 45%, the compressive bearing capacity of all pile groups was greater than their tensile bearing capacity under similar conditions. The compressive bearing capacities of the two-pile single-helix group, two-pile double-helix group, three-pile group with single-helix side piles, three-pile group with double-helix side piles, and four-pile group in the 3D arrangement were 104%, 179%, 58%, 75%, and 112% higher, respectively, than the corresponding tensile bearing capacities. Under one-way cyclic loading and at a relative density of 45%, tripling the spacing between piles increased the number of cycles by 80%, 50%, and 18% in the first, second, and third tests, respectively, for the two-pile single-helix group; by 77%, 43%, and 26% for the two-pile double-helix group; by 38%, 53%, and 80% for the three-pile group with a central double-helix pile; by 45%, 46%, and 55% for the three-pile group with a central single-helix pile; and by 24%, 37%, and 50% for the four-pile group. Under two-way cyclic loading and at a relative density of 45%, tripling the spacing between piles increased the number of cycles by 37%, 38%, and 50% in the first, second, and third tests, respectively, for the two-pile single-helix group; by 48%, 53%, and 63% for the two-pile double-helix group; by 21%, 29%, and 24% for the three-pile group with a central double-helix pile; by 29%, 36%, and 45% for the three-pile group with a central single-helix pile; and by 13%, 16%, and 13% for the four-pile group.
Keywords:
#Keywords: Helical Pile Group #Monotonic Loading #Cyclic Loading #Bearing Capacity #Physical Modeling. Keeping place: Central Library of Shahrood University
Visitor: